Multi-Router

I am extremely impressed with the Multi-Router made by the JDS Company, and that is why I have decided to become a distributer.
It has increased my proficiency more than any single tool in the shop. Once set-up, it can repeat the same cut indefinitely to within a few thousands of an inch . When the pneumatic hold-downs are added, it becomes a serious production machine.
The Multi-Router is extremely versatile: the possibilities are almost endless.

I will be glad to answer any questions you may have any questions concerning the Multi-Router. If I do not know the answer I will contact the folks at JDS and get an answer for you.
I am also available (by appointment) to demonstrate the Multi-Router here in my shop in Auburn Washington.
To place an order please call (425 277 4070) or email me. If you would like a price sheet mailed to you please send me your postal address.

 

Specifications
  • Constructed of heavy aluminum castings.
  • Computer controlled machining of all parts.
  • Three axis operation: X Axis-8 inches, Y Axis-8 inches, and Z Axis-6 inches.
  • Thompson Linear bearing and hardened steel rods.
  • 'Adjustable stop collars.
  • Gas cylinder counter balance to offset the weight of the router.
  • Removable locator pins on work surface table.
  • Chip deflector.
  • Work table tilts to a full 45 degrees.
  • Accurate scale for height selection of Z axis.
  • Designed to accommodate most routers.

 

 

 

(shown with pnepneumatic hold-downs)

 

 

 
 

 

 

 

Send Email To Darrell Peart

    Call / Voice mail : (425)277-4070

 

Dining Room  - Bedroom - Living room/Office   About Darrell Peart  -  About the Furniture  -  Home  -
  Newsletter Suggested  Reading - Links  -  Ordering   - Commissioning  Custom Work - BookPurchase--Woodworking Classes - G&G Yahoo Group - G&G at Antique Road Show - Work in Progress